Alternative - Photograv

The alternatives listed above are not compromises; they are evolutions. A polymer photogravure is not "fake gravure"; it is gravure for the 21st century. An electroetched copper plate is not a shortcut; it is a smarter path.

The best alternative is the one that gets you into the studio, pulling prints, and chasing that impossible, velvety black. Because in the end, the viewer does not care if the grain came from rosin dust or a stochastic screen. They only care if the image has soul . And that is something no process—traditional or alternative—can manufacture. photograv alternative

While traditional gravure has a soft, painterly edge, polymer intaglio has a sharper, more photographic edge. To mimic the soft halation of gravure, artists use diffusion filters during exposure or slightly defocus the UV light source. Part IV: The Hybrid Electroetch (EDM for Printmakers) For those who crave the permanence and feel of a true metal plate (copper or zinc) but recoil from ferric chloride or nitric acid, electrolytic etching (electroetch) is the answer. The alternatives listed above are not compromises; they

The good news is that the pursuit of that distinctive gravure look —a continuous-tone, painterly image with a rich physical presence—has never been more accessible. Today, a new generation of non-toxic, low-tech, and hybrid processes can replicate, and in some cases surpass, the aesthetic of traditional photogravure. The best alternative is the one that gets

You prepare a metal plate with a conductive ground (e.g., a hard ground or a photoresist). You then place the plate in an electrolytic bath (usually a saltwater or copper sulfate solution) with a DC power supply. The plate acts as the anode. Electrical current dissolves the metal where it is exposed.

Instead of sensitizing gelatin with dichromate and exposing it through a film positive onto a copper plate, you expose a pre-sensitized, light-hardening polymer layer on a steel or aluminum backing. The unexposed areas are washed away with warm water, leaving a relief of hardened polymer. The plate is then inked and wiped exactly like a copper gravure plate.