New- Hints And Kinks For The Radio: Amateur

WD-40 leaves a residue that attracts dust. This alcohol+oil method flushes oxidation then leaves a clean, thin lubricant film. 7. The "No-Drill" Ground Bus for a Metal Desk The problem: Your station ground needs a common bus bar, but you don’t want to drill into your nice metal desk or filing cabinet.

Before snapping the bead onto the cable, wrap the coax with one layer of friction tape (cloth electrical tape) or two wraps of vinyl electrical tape where the bead will sit. Then push the bead over the taped section.

Strip the insulation off a length of stranded hookup wire (16–22 AWG). Unravel the braided shield or simply flatten the stranded core. Dip the bare copper in rosin flux (paste or liquid). Apply your soldering iron to the joint and touch this makeshift wick to the molten solder. New- Hints and Kinks for the Radio Amateur

Buy a silicone baking mat (meant for cookies, about $10–15). They are heat resistant to 450°F, non-slip, and have a slight lip. The best part: the non-stick surface means solder balls don’t adhere—they just roll into a corner for easy vacuuming.

Remove the knob. Drip 2–3 drops of isopropyl alcohol (91% or higher) into the shaft opening. Rotate the pot back and forth fully 20–30 times. Let it dry 5 minutes. Then add one tiny drop of lightweight machine oil (sewing machine oil or even 3-in-1) to the same spot. Rotate again 10 times. WD-40 leaves a residue that attracts dust

Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles).

Zero adhesive residue. Removes cleanly. UV and weatherproof for years. Temperature range: -60°F to +500°F. One roll seals dozens of connectors. Use it over electrical tape, not under. 5. The Ruler-on-the-Mast Trick (Antenna Matching) The problem: You’re tuning a 1/4-wave ground plane or a J-pole. You slide the radiator up and down, mark it with a Sharpie, lower the mast, adjust, raise again… repeat. The "No-Drill" Ground Bus for a Metal Desk

73, and may your SWR be low and your soldering iron hot. Do you have a kink to share? Send it to your club newsletter or post it on QRZ—that’s how our tradition stays alive.

Loosen the element set screw. Slide the element until it touches the clamp. Tighten. Check SWR. Move clamp up or down by measured inches. No more lowering the mast 15 times. 6. Cleaning Potentiometers Without Deoxit (Field Hack) The problem: Scratchy volume or tone control on your vintage receiver, and you’re out of contact cleaner.

This is for RF ground and equipment bonding , not for lightning or AC safety ground. Always keep your AC safety ground separate and intact. 8. Silicone Baking Mat = Portable Work Surface The problem: Tiny screws, washers, and springs roll off your bench and into the abyss (also known as the carpet).

Use a metal eyeglass repair screwdriver (the flat kind that comes in those little keychain kits). The tip is exactly the right width to fit into the two holes of a standard knurled SMA plug. Insert the tip into one hole and use it as a lever for that final gentle snug.