Lm3915 Calculator -

[ V_\textth,n = V_\textRLO \times 10^(n-1)/10 \times \fracV_\textRHIV_\textRLO \times 10^9/10 ]

Example: For 20 mA (typical bright LED), ( R_\textset = 12.5 / 0.02 = 625 \ \Omega ). Use 620 Ω standard. Design goal: Audio level meter for -30 dBV to +6 dBV (36 dB range, but LM3915 only does 30 dB, so compress or shift). Desired: LED1 = -30 dBV, LED10 = 0 dBV (30 dB span). Reference voltage = 5.0 V (from 12V supply). LED current = 15 mA. LM3915 Calculator

RLO = 0 V (ground). RHI = 5.0 V (to reference). But now the highest LED triggers at ( V_\textin \approx 5.0 ) V peak? That’s far above 1.414 V. So we must attenuate input. Desired: LED1 = -30 dBV, LED10 = 0 dBV (30 dB span)

[ \textAttenuation factor = \fracV_\textref,desiredV_\textmax ] RLO = 0 V (ground)

[ R2 = R1 \times \left( \fracV_\textref1.25 - 1 \right) ]

Typically ( R1 = 1.2 \textk\Omega ) (recommended min). Example: To set ( V_\textref = 2.5 \textV ), ( R2 = 1200 \times (2.5/1.25 - 1) = 1200 \times 1 = 1.2 \textk\Omega ). If the lowest LED lights at ( V_\textin = V_\textLO ) and the highest at ( V_\textin = V_\textHI ), then:

| Problem | Consequence | |---------|--------------| | Choosing R1/R2 for a specific full scale | Incorrect clipping level | | Converting dBu or dBV to required input voltage | Mismatch with line-level audio | | Setting RLO/RHI for offset display (e.g., -20 dB to +10 dB) | First LED never lights | | Resistor selection for precise 1 mA/LED | Burnout or dim display |