10 Industrial Electrical Training Video Course Library -

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | How 3-phase induction motors work – rotating magnetic field | Animated stator/rotor interaction | | 2 | Motor nameplate: voltage, FLA, RPM, service factor, insulation class | Read 5 real nameplates | | 3 | Single-phase vs. three-phase motors | Capacitor-start motor teardown | | 4 | DC motors – series, shunt, compound | Small DC motor demo with speed control | | 5 | Motor efficiency & power factor basics | Compare efficiency labels |

Calculate expected full-load current given HP, voltage, and efficiency. Course 4: Motor Starters & Contactors Focus: Manual and magnetic starters, contactor operation, overload relays.

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | VFD block diagram: rectifier → DC bus → IGBT inverter | Measure DC bus voltage | | 2 | Basic programming – acceleration, deceleration, motor nameplate entry | Program a PowerFlex or Altivar | | 3 | Control wiring – 2-wire vs. 3-wire start/stop | Wire external run/fwd/rev | | 4 | Motor cable length, reflected wave, and output reactors | Show oscilloscope of voltage spikes | | 5 | Common faults – overvoltage, overcurrent, ground fault | Diagnose a fault log | 10 Industrial Electrical Training Video Course Library

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Digital multimeter (DMM) basics: V, A, Ω, continuity | Measure line voltage (120V/480V) | | 2 | Clamp meter – measuring current without breaking circuit | Measure motor FLA in a panel | | 3 | Insulation resistance tester (megohmmeter) | Test motor winding insulation | | 4 | Non-contact voltage tester & solenoid tester | Verify absence of voltage | | 5 | Understanding test lead categories (CAT III / CAT IV) | Compare meters for industrial use |

Fix a VFD tripping on “Overvoltage” during deceleration. Course 8: Electrical Schematics & Panel Troubleshooting Focus: Reading industrial drawings, finding shorts, opens, and ground faults. | Segment | Topic | Key Demo |

Identify correct PPE for a Category 2 arc flash hazard. Course 2: Multimeter & Electrical Test Equipment Focus: Proper use of DMMs, clamp meters, insulation testers, and voltage testers.

Design a conveyor start/stop with a 5-second delayed start. Course 7: Variable Frequency Drives (VFDs) – Setup & Troubleshooting Focus: VFD components, programming, motor protection, and common faults. Identify correct PPE for a Category 2 arc flash hazard

| Segment | Topic | Key Demo | |---------|-------|-----------| | 1 | Megger test procedure – phase-to-phase & phase-to-ground | Acceptable values for 480V motor | | 2 | Surge comparison test for turn-to-turn shorts | Compare good vs. bad waveform | | 3 | Motor bearing types & replacement (grease vs. oil) | Pull a bearing with a puller | | 4 | Shaft alignment – dial indicator vs. laser alignment | Demonstrate soft foot | | 5 | Analyzing failed windings – overload, single-phasing, contamination | Show 5 failed stator photos |

Focus: NFPA 70E, arc flash, lockout/tagout (LOTO), and hazard recognition.